Features And Controls - Briggs & Stratton 540000 Vanguard Gaseous Manual Del Operario

Features and Controls

1
Compare the illustration with your engine to familiarize yourself with the location of
various features and controls.
A. Engine Identification
Model Type Code
B. Spark Plug
C. Air Cleaner, Low Profile
D. Dipstick
E. Oil Fill
F. Oil Filter
G. Oil Drain Plug
H. Oil Pressure Sensor
I. Finger Guard / Rotating Screen
J. Electric Starter
K. Starter Solenoid
L. Regulator/Rectifier
M. LPG/NG Mixer
N. Oil Cooler
O. Muffler
Operation
Oil capacity (see the Specifications section)
Oil Recommendations
We recommend the use of Briggs & Stratton Warranty Certified oils for best
performance. Other high-quality detergent oils are acceptable if classified for service SF,
SG, SH, SJ or higher. Do not use special additives.
Outdoor temperatures determine the proper oil viscosity for the engine. Use the chart to
select the best viscosity for the outdoor temperature range expected.
°F
Below 40°F (4°C) the use of SAE 30 will result in hard starting.
*
** Above 80°F (27°C) the use of 10W-30 may cause increased oil consumption. Check
oil level more frequently.
How To Check/Add Oil - Figure 2
Before adding or checking the oil
Place engine level.

Clean the oil fill area of any debris.

1. Remove the dipstick (A) and wipe with a clean cloth (Figure 2).
2. Insert and tighten the dipstick.
3. Remove the dipstick and check the oil level. It should be at the top of the full indicator
(B) on the dipstick.
4. If low, add oil slowly into the engine oil fill (C). Do not overfill. After adding oil, wait
one minute and then recheck the oil level.
5. Replace and tighten the dipstick.
6
Low Oil Protection System (if equipped)
Some engines are equipped with a low oil sensor. If the oil is low, the sensor will either
activate a warning light or stop the engine. Stop the engine and follow these steps before
restarting the engine.
Make sure the engine is level.

Check the oil level. See the How To Check/Add Oil section.

If the oil level is low, add the proper amount of oil. Start the engine and make sure

the warning light (if equipped) is not activated.
If the oil level is not low, do not start the engine. Contact an Authorized Briggs &

Stratton Dealer to have the the oil problem corrected.
Fuel Recommendations
Do not operate the equipment if the "fuel lock-off" valve is missing or inoperative.

Fuel must meet these requirements:
Use clean, dry fuel, free of moisture or any particulate material. Using fuels outside

the following recommended values may cause performance problems.
In engines set up to run on LPG, commercial grade HD5 LPG is recommended.

Recommended fuel composition is fuel with a minimum fuel energy of 2500 BTU's/ft
with maximum propylene content of 5% and butane and heavier gas content of 2.5%
and minimum propane content of 90%.
NG or LPG engines are certified to operate on natural or liquid propane gas. The
emissions control system for this engine is EM (Engine Modifications).
WARNING:
with an automatic safety gas "fuel lock-off" valve. Do not operate the equipment if the
"fuel lock-off" valve is missing or inoperative.
°C
How To Add Fuel
When Adding Fuel
Fill fuel tank outdoors or in well-ventilated area.

Check fuel lines, tank, cap, and fittings frequently for cracks or leaks.

Replace if necessary.
For information on refueling natural or LP gas engines, read the operating instructions
supplied by the equipment manufacturer.
How To Start And Stop The Engine
When Starting Engine
Ensure that spark plug, muffler, and air cleaner (if equipped) are in place and

secured.
Do not crank engine with spark plug removed.

WARNING
Missing or inoperative "fuel lock-off" valve can cause a fire or
explosion.
The equipment on which this engine is mounted is equipped
WARNING
Fuel and its vapors are extremely flammable and explosive.
Fire or explosion can cause severe burns or death.
WARNING
Fuel and its vapors are extremely flammable and explosive.
Fire or explosion can cause severe burns or death.
3
VanguardEngines.com