Whittier Wood Products 732W Hoja De Instrucciones Para Armado Inmediato página 10

FIG. 13
13) Attach the Double Magnetic Catch (ZO) to the bottom of the crown spacer centered side to side
and flush with front edge using pan head screws included in catch kit. Attach the catch plates to
the upper inside edge of the upper doors where they will make contact with the magnetic catch
using flat head screw included in the catch kit.
Mount the Single Magnetic Catches (ZN) for the lower doors to the vertical divider below the center
shelf, flush with the front edge of the vertical divider. Mount one slightly below the other so that the
screws for both catches will not be exactly opposite.
Attach the catch plates to the upper inside edge of the lower doors where they will meet the
catches.
ZF
FIG. 14
14) Attach the Knobs (ZB) to the doors using #8 x 1" Machine Screws (ZF).
15) Install Adjustable Shelves (U&V) in desired locations using the Shelf Brackets (ZC). Fasten in
place with #6 x 3/8" Brass Screws (ZE). The holes for the shelf brackets are staggered so that if
you want them at the same level, use the front holes in one side of the vertical divider and the back
holes on the other side.
PAGE 10 — 732W
ZO
FIG. 13A
ZB
ZN
ZN
V
ZO & ZN
FIG. 13B
ZE
FIG. 15
ZC