Whittier Wood Products 732W Hoja De Instrucciones Para Armado Inmediato página 6

ZJ
F
GLUE
E
FIG. 4A
4) Attach both the Left Foot (F) and Right Foot (G) to the Base (E) with glue and two 2" Black Screws
(ZJ). Make sure that the ends and back of feet are flush with base. Attach the Base (E) to the Bottom
Shelf (CB) with Cam Housings (ZL).
Attach the Center Shelf Moulding (D) to the front of the Center Shelf (CC). Use four Cam
Connectors (ZK) and Cam Housings (ZL). The moulding will overhang the bottom of the shelf.
ZI
5) With the notch for the embossed emblem toward the bottom, attach the Crown Spacer (M) to the
Crown (H) with three 1¼" Black Screws (ZI) through the lower predrilled holes in the crown into the
pilot holes in the crown spacer. The upper unused holes in the crown and crown spacer should line
up. The top edge of the crown spacer will be about one inch below the top edge of the crown. Glue
the Embossed Moulding (N) into the groove in the crown spacer.
PAGE 6 — 732W
ZJ
GLUE
FIG. 5
E
F
ZL
ZL
G
CB
H
M
N
ZL
FIG. 4
FIG. 5A
D
M
N