Escalade Sports Prince T8840 Manual Del Usuario página 11

HARDWARE NEEDED
1/4-20 x 1 1/4" Bolt
32
(Qty. 4)
9 1/4-20 x 1 1/2 Bolt
(Qty. 2)
1/4-20 x 2" Bolt
14
(Qty. 2)
18. Attach other end of linkages #4 to OUTSIDE
of U-support #7 with bolts #14 and plastic
washers #24. Then slide name panel #5
onto the same bolts #14 on the INSIDE of
U-support #7. Secure with lock nuts #15 See
Figure 7C. Tighten hardware until snug but
do not overtighten. Tubes must pivot freely.
19. Attach bottom of name panel #5 to
U-supports #7. Secure with hex
bolts #9 and locknuts #15. Tighten
nuts but be careful not to crush
tubes. See Figure 7C.
20. Attach bottom board #18 to
name panels #5, as shown in
Figure 7C, using four bolts #32
and four hex nuts #15.
21. Prepare an area for the assembly of the second table top half. If
necessary, move the first table top half aside with the aid of a helper. Be
sure to place it in a location where it won't be disturbed or damaged. If
setting on its side, be sure to place the bottom edge no less than 12
inches away form the wall. Also be sure to place carpet or pieces of the
shipping carton down to protect table top edges. If floor is not carpeted,
brace table top half with a heavy object to keep it from sliding.
15
¼" Locknut
(Qty. 8)
7
9
24
Plastic Washer
24
14
(Qty. 2)
Logo on
#5 panel
5
15
faces out
32
15
First Table Top
Figure 7C
11
CAUTION:
AT LEAST TWO ADULTS ARE NEEDED TO
MOVE TABLE HALF!
18
32
7
15
Logo on
#5 panel
faces out
15
5
9
24
14
4