Kohler K-6354 Guia De Instalacion página 3

Faucet Body
Threaded Hole
Mounting Stud
1. Install the Mounting Stud
- Screw the mounting stud into the threaded hole at the bottom of the
faucet body. The mounting stud should extend slightly beyond the
threaded hole in the body.
2. Install the Escutcheon (optional)
NOTE For installation on marble, do not use plumbers putty. Use
:
the self-adhesive gaskets provided. Remove the paper backing and
apply the gaskets (adhesive side down) over the outside holes.
- For 1-hole installations: The escutcheon, spacer, and O-ring are not
required. Slide the rubber washer over the faucet tubing and hose.
- Insert the faucet tubing and hose into the hole.
- For 3-hole installations: Apply a ring of plumbers putty to the
underside of the escutcheon.
- Insert the O-ring into the groove in the spacer.
- Slide the rubber washer, escutcheon, and spacer (O-ring side down)
over the faucet tubing and hose.
- Insert the faucet tubing and hose into the center hole, carefully
aligning the escutcheon. Press down on the escutcheon and remove
any excess putty.
Kohler Co.
Faucet
Body
Rubber
Washer
Escutcheon
3
Spacer With
O-Ring
A
1025491-2-