Swing-N-Slide PB 9210 Instrucciones De Ensamblaje página 11

•WARNING•
Avoid splitting your
lumber by offsetting
your screws at least
3/4'' from edge.
Fig. 2
(3)
2-1/2'' screws
per joint
(2) 1-1/4'' lag screws
and
(2) 2'' lag screws
per bracket
(3)
2-1/2'' screws
per joint
rame 1
Frame Assemblies Cont.
1. Attach 5/4'' boards as shown in (Fig. 2) and (Fig. 2a).
2. Attach 2'' x 4'' and 4'' x 4'' boards as shown in (Fig. 2)
through (Fig. 2b).
Fig. 2a
(3)
2-1/2'' screws
per joint
(4)
2'' lag screws
per joint
(2) 1-1/4'' lag screws
and
(2) 2'' lag screws
per bracket
(3)
2-1/2'' screws
per joint
rame 2
11
PB 9210 ssembly Instructions
Look for ''TOP''
stamp on brackets
while installing.
Fig. 2b
DO NOT USE LAG
SCREW HERE
NOTE: Upper screws are (2) 1-1/4'' Lag
Screws, Lower screws are (2) 2'' Lag
1-1/4'' Lag screw
2'' Lag screw
2-1/2'' screw
Use a 2'' lag screw
to hold bracket in
place for later use.
(2)
1-1/4'' Lag
(2)
2'' Lag
Screws.