Swing-N-Slide PB 9210 Instrucciones De Ensamblaje página 24

PB 9210 ssembly Instructions
(6) 5/4'' x 6'' x 25''
3/4'' GAP
(2)
2-1/2'' Screws
per joint
Fig. 15a
(2) 1-1/4'' Hex Head Bolts
Rock Wall Assembly
1. Assemble Rock Wall as shown in (Fig. 15).
2. Mark locations of Climbing Rocks on the Rock Wall in a pattern that will easily allow your child to climb to the deck.
Make sure the bolt hole locations are clear of wall supports before drilling.
3. Drill holes through the wall at the desired locations using a 3/8" drill bit. Install Climbing Rocks as shown in
(Fig. 15a).
4. Make sure the Rock Wall and Climbing Rock connections are secure before allowing any children to play on the Rock
Wall.
5. Attach Rock Wall as shown in (Fig. 15b).
Fig. 15
Note: 2-3/4'' GAP
TYP.
(2)"T" nuts
3/8" Holes
Hold (rock)
(1) Loc Washer per bolt
(1) Flat Washer per bolt
2-1/2'' screw
24
Fig. 15b
(3)
2-1/2'' Screws
per joint