Swing-N-Slide PB 9210 Instrucciones De Ensamblaje página 28

PB 9210 ssembly Instructions
Fig. 19a
Climbing Rope
1. Secure top of Climbing Rope on the bottom center of the 2'' x 4'' x 32'' as shown in (Fig. 19b).
2. Using two rope staples secure the bottom of the climbing rope. Tap two staples in place approximately 1'' apart.
Wrap the rope under the 5/4'' x 6''. Then thread the rope through both staples. Double the rope back on itself and
through the first staple. Pull the rope tight and secure in place by pounding staples in place. See (Fig. 19).
3. Once you have Secured end of climbing, rope cut off any excess with a sharp knife or scissors.
1''
1''
28
Fig. 19
2'' Lag screw
Fig. 19b
Eye Strap
(2)
2'' Lag Screws