Swing-N-Slide PB 9210 Instrucciones De Ensamblaje página 30

PB 9210 ssembly Instructions
Fig. 22a
NEVER hang a swing seat by a
partial link of chain! Remove and
discard partial links.
Fig. 22b
Swing Seat Assembly.
Fig. 22
1. Hold the swing seat vertically and insert uncoated chains through the
channels on the bottom of the swing seat. Note: A coat hanger may be
used to help pull chain through the swing seat. One full link should show at
each end of the seat (Fig. 22).
2. Place one covered chain onto each harness so that it fits at the top of the
V-hanger. Insert uncoated chains to bottom vinyl hooks of V-hanger.
(Fig. 22b). Crimp harness end closed.
CAUTION: It is important that you crimp harness ends
completely closed before using (see Fig. 22b). Place end of harness
with hooks on a hard surface and force hooks closed with a hammer or
squeeze closed with a pliers until parts are touching.
WARNING: Open hooks can cause deep cuts.
3. Hang the chains from the nylon bushing swing hangers. Crimp the hook
opening closed with a pliers to secure the chains to the swing hangers
(Fig. 22c). Make sure all connections are tightly crimped and secure
before using swing seat.
Ring-Trap Assembly:
1. Attach chains to Quick Links as shown in (Fig. 23).
2. Attach Quick Links to Ring-Trap as shown in (Fig. 23a).
3. Hand tighten quick Links as shown in (Fig. 23b).
4. Tighten BOTH Quick Links with a wrench as shown in (Fig. 23c).
5. Hang the chains from the nylon bushing swing hangers. Crimp the hook
opening closed with a pliers to secure the chains to the swing hangers
(Fig. 22c). Make sure all connections are tightly crimped and secure
before using Ring-Trap.
Fig. 23
Fig. 22c
Fig. 23b
30
Fig. 23a
Fig. 23c