Swing-N-Slide PB 9210 Instrucciones De Ensamblaje página 31

Fig. 24
Anchor-It Installation.
I I n n s s t t r r u u c c t t i i o o n n s s f f o o r r A A n n c c h h o o r r i i n n g g S S w w i i n n g g • • N N • • S S l l i i d d e e A A c c t t i i v v i i t t y y C C e e n n t t e e r r s s
1. Determine the final location of your activity center.
2. Place the Anchor-It stakes adjacent to the base and near the corners of your activity center (at the bottom of the
legs on swing sets) and twist the auger-style stakes into the ground until only the loop is exposed.
3. Place the metal strap through the loop of the Anchor-It stake and secure it to the unit with a lag screw and
washer as illustrated to the right. Note: Attach the strap to the unit with as little play as possible using whatever
holes in the strap that work best.
PB 9210 ssembly Instructions
Anchor-It
metal strap
Anchor-It
31
Flat Washer
1-1/2"
lag bolt