Swing-N-Slide Timber-Bilt Turbo Tube Slide Instrucciones De Ensamble página 24

ASSEMBLY INSTRUCTIONS
2" x 4" x 47"
5/4" x 6" x 30"
30"
2" x 4" x 27"
2" x 6" x 27"
24
FIGURE 8
2" x 4" x 37-1/4"
5/4" x 6" x 30"
FIGURE 9
2" x 4" x 37-1/4"
2" x 4" x 27"
2" x 6" x 27"
BOTTOM RAIL INSTALLATION
1. Attach a 2" x 4" x 37-1/4" rail support
to the front of the tower using four 3"
screws per joint. NOTE: The top of the
rail support should be approximately
30" from the bottom of the unit.
2. Attach two 2" x 4" x 47" rail supports
to the sides of the tower as shown in
Fig. 8 using four 3" screws per joint.
3. Evenly space five 5/4" x 6" x 30" rail
uprights in each side opening as
shown in Fig. 8. Attach the uprights to
the supports using two 2" screws at
the top and bottom of each board.
4. Evenly space four 5/4" x 6" x 30" rail
uprights in front of the tower as shown
in Fig. 8. Attach the uprights to the
supports using two 2" screws at the
top and bottom of each board.
FINAL TOWER ASSEMBLY
1. Attach a 2" x 4" x 37-1/4" directly
beneath the existing 2" x 6" using four
3" screws per joint.
2. Attach the two remaining 2" x 4" x 27"
and two 2" x 6" x 27" boards as
shown using four evenly spaced 3"
screws.