Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
ASSEMBLY INSTRUCTIONS
FIGURE 1
Entrance Section - 14 bolts
Sección de Entrada
Section d'entrée - 14 boulons
FIGURE 2
Exit Section - 13 bolts
Sección de salida-13 pernos
Section de sortie - 13 boulons
28
- 14 pernos
flanged lip
labio levantado
bord relevé
flat lip
labio plano
bord plat
90° Section (2 are required) - 13 bolts each
Sección 90° (se requieren 2) - 13 pernos cada una
Section à 90° (2 requises) - 13 boulons chacune
ENTRANCE SECTION, 90° SECTION (2)
AND EXIT SECTION
NOTES:
• At least two individuals are needed to
assemble the Turbo Tube Slide.
• To aid in aligning holes when assembling
sections, insert a screwdriver through adjacent
holes to maintain hole alignment.
1.
Identify each slide section as either (1), (2),
(3), (4), (5), or (6) as marked on the lip of each
piece.
2.
Assemble entrance section using pieces (1) &
(2), two 90° sections using pieces (3) & (4),
and the exit section using pieces (3) & (5).
Join sections using a 3/4" hex head bolt, two
flat washers, and a loc nut at each hole
junction (FIGURES 1, 2 & 3). NOTE: Fasten
each loc nut finger tight until the entire slide is
assembled. Each time you join parts be sure
each flanged lip is mating with a flat lip.
3/4" bolt
3/4" perno
boulon de 3/4 po
washer arandela rondelle
washer arandela
loc nut
tuerca
écrou de blocage
FIGURE 3
rondelle
Publicidad
Tabla de contenido
