Swing-N-Slide Timber-Bilt Turbo Tube Slide Instrucciones De Ensamble página 32

ASSEMBLY INSTRUCTIONS
FIG.URE 7
Rotate seam
two holes to
the right
(clockwise)
Girar el
dobladillo de
los agujeros a
la derecha
Tourner le joint
de deux trous
vers la droite
(sens des
aiguilles d'une
montre)
FIGURE 8
Rotate seam two
holes to the left
(counterclockwise)
Girar el dobladillo
de los agujeros a la
izquierda
Tourner de deux
trous vers la
gauche (sens
contraire à celui
des aiguilles
d'une montre)
32
TUBE ASSEMBLY
1. Position the 90° section to the entrance section
so the seams line up. Rotate the section two
holes to the right (clockwise) and realign with the
holes of the entrance section (see FIGURE 7).
2. Insert a 3/4" bolt through a washer, through the
holes of slide sections, a second washer and
secure with a loc nut.
NOTE: Insert first bolt and continue in a
clockwise rotation. Do not skip holes. Hand
tighten the loc nuts only at this time.
3. Position the 90° section to the previously attached
section so the seams line up. Rotate the section
two holes to the left (counterclockwise) and
realign with the holes of the entrance section (see
FIGURE 8).
4. Insert a 3/4" bolt through a washer, through the
slide sections, a second washer and secure with
a loc nut. NOTE: Hand tighten the loc nuts only at
this time.