Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
ASSEMBLY INSTRUCTIONS
FIGURE 13
exit section
sección de salida
section de sortie
FIGURE 14
2" x 4" x 9-1/4"
2" x 4" x 20"
FIGURE15
38
slide bracket
braqueta del resbaladero
support de glissoire
2" x 4" x 7"
2" x 4" x 20"
2" screws
tornillos de 2"
vis de 2 po
2" x 4" x 9-1/4"
3" screws
tornillos de 3"
vis de 3 po
1-1/2" lag bolts
pernos de retraso
de 1-1/2"
tire-fonds de 1 1/2po
support bracket
braqueta de soporte
ferrure de support
SUPPORT AND BRACKET ASSEMBLY
1. Position the slide bracket between the slide and
activity center (FIGURE 13). Remove
appropriate bolts from the slide (the fourth and
fifth bolts as indicated), Attach bracket to the
underside of the seam using the previously
removed hardware (FIGURE 13).
2. If necessary, move slide towards the activity
center until the slide bracket makes contact with
the unit. Using holes in the bracket (indicated by
arrows in FIGURE 13) as a guide, mark and
drill 1/8" pilot holes (1" deep). NOTE: You may
need to temporarily remove the slide bracket to
drill the pilot holes.
3. Re-attach bracket (if necessary) and secure it to
the unit using two 1-1/2" lag bolts .
4. Assemble the support base as shown in
FIGURE 14. NOTE: Use four 2" screws to
fasten the 2' x 4' x 9-1/4" boards and 3" screws
for remainder of assembly.
5. Attach the support bracket to the support base
using two 1-1/2" lag bolts (FIGURE 15).
NOTE: Pre-drill 1/8" pilot holes.
6. Place the support beneath the slide base and
determine its final position. NOTE: Slide
support should fit tightly beneath the slide to
assure proper support. Remove corresponding
nut and bolt, attach support to the slide as
indicated in FIGURE 16. Re-attach hardware.
7. Level grade at the bottom of the slide.
1-1/2" bolt
1-1/2" perno
boulon de 1-1/2 po
loc nuts
tuercas
écrous de
washer
blocage
arandela
rondelle
FIGURE 16
Publicidad
Tabla de contenido
