Unpacking Your Wet/Dry Vacuum & General Assembly - Vacmaster PROFESSIONAL DVTB204 0201 Manual Del Operador

Components:
1. Vacuum Port
2. Handle
3. Built-in Measurement Ruler
4. Bottle Opener
5. Toolbox Cover
6. Cover Latches (right and left)
7. Hose Storage
8. Collection Tank Latches (front and back)
9. Collection Tank
10. Blower Port
11. Extension Wand Storage
12. Floor Nozzle
UNPACKING YOUR WET/DRY VACUUM
1. Verify that the battery pack is not installed.
2. Undo the latches.
3. Remove the contents from inside the collection tank; make sure you have all contents as listed
on page 9.
INSTALLING & REMOVING THE HOSE
1
1. Pull one end of the hose out of the hose storage (Fig. 1).
2. Connect the other end of the hose to the vacuum port; make sure it is secure.
3. This wet/dry vacuum has blowing capabilities. To use as a blower, connect the hose to the
blower port (Fig. 2).
INSTALLING & REMOVING ACCESSORIES
3
1. To remove the extension wands, pull each wand from its storage slot at the bottom of the vac
(Fig. 3).
2. Choose the desired accessories and extension wands and push onto the hose (Fig. 4 & 5).
& GENERAL ASSEMBLY
2
4
13. Crevice Tool
14. Tool Storage
15. Battery Bay Cover
16. On/Off Switch
17. Battery Bay
18. Battery
19. Charger
20. Shoulder Strap
21. Hose
22. Filter
23. 1-7/8" to 1-1/4" Adapter
24. Inflator Nozzle Adapter
5
9