LAZBOY PowerRecline XR Instrucciones De Operación página 9

PowerReclineXRw
Assembly Instructions
4. Locate the power supply connector, one behind each reclining seat (F
transformer connector to the power supply connector, push together until fully seated and close
the locking cover to secure the connection (F
5. Connect the 120 volt power cord to the power transformer (F
instructed in the Operating Instructions.
6. Proceed to the Battery Backup Assembly Instructions.
To Remove the Back:
1. Unplug the 120 volt power cord from the electrical outlet and disconnect the power transformer
connector from the power supply connector.
2. Taking care not to damage the cover, insert a screwdriver between the arm and back and engage
the locking lever on the back bracket (F
3. Push up on the locking lever until the lever is at 45 to 30 degrees from vertical (F
4. Repeat steps 2 and 3 for the other side of the back, inserting the screwdriver between
the rear post and back.
5. The back is free to remove at this point. Lift up on the back to remove.
(Assembly Instructions Continued)
16
™ Motion Sofa
7). Align the power
IGURE
8). Do this for each reclining seat.
IGURE
9). Do not plug in until
IGURE
10).
IGURE
IGURE
F 7
IGURE
10).
F 9
IGURE
Make this
connection
120 Volt
Power Cord
PowerReclineXRw ™ Motion Sofa
Assembly Instructions
F
IGURE
Make this
connection
Power Supply Connector Power Transformer
F
IGURE
Back
Bracket
Power
Transformer
8
Power Supply Connector
10
45 Degrees
from
Vertical
Locking
Lever
17