Tools Required - Whittier Wood Products 784W Instrucciones Para Armar

772W & 784W WALL UNITS
ASSEMBLY INSTRUCTIONS

TOOLS REQUIRED:

Phillips Head Screwdriver, Mallet or Padded Hammer and Tape Measure.
IMPORTANT:
We recommend finishing the unit before final assembly. Before finishing, read the
enclosed Finishing Hints sheet.
Note: Due to the fact that more than one type of hardwood is used,
we recommend testing for desired color.
To test for desired color on:
a) Veneer parts – apply stain to unexposed portion of side panels. See FIGURE 2.
b) Alder pieces – apply stain to back of base. See FIGURE 3.
772W Wall Unit shown
FIG. 1
in all drawings.
1. Lay out the wood parts in their approximate locations to aid in the identification and assembly.
772W & 784W – PAGE 3