Technical Specifications; Dead Space Information; Replacement Parts - ResMed Ultra Mirage Manual Del Usuario

3 Insert the assembled valve into the mask
frame (Fig. F-3).
Note: The valve must be assembled
(as depicted in Figure E-4), before it is
inserted into the mask frame.
4 Hold the mask frame and the inserted
valve firmly together.
5 To attach the elbow retainer, fit one
side of the elbow retainer against the
groove of the valve. While holding one
wing of the elbow retainer down
(Fig. F-4a), press the other wing down
until the elbow retainer clicks into place
(Fig. F-4b).
6 Rotate the elbow retainer to its original
position (Fig. F-5).
7 Check that you have fitted the valve and
elbow retainer correctly by firmly pulling
the valve away from the frame. If the
valve is fitted correctly, it should not
separate from the frame.
If the valve comes away from the frame,
try refitting the elbow retainer as
described in Steps 4 and 5. If the valve
still comes away from the frame when
you pull on it, you may need to replace
the elbow retainer with a new one.
8 Fit the grooved edge of the mask
cushion to the mask frame. Fit the top
section first, then work your way around
the mask, pushing the cushion onto the
frame, ensuring a good seal has been
achieved.
Then push the cushion clip over the
cushion onto the mask frame, ensuring it
clicks into place in all locations (Fig. F-6).
9 Attach the forehead pads to the
forehead support by inserting the pad
plugs into the two holes on the back of
the forehead support (Fig F-7). Push the
pads firmly against the forehead support
to ensure that the pads fit securely into
the forehead support.
10 Connect the forehead support to the
mask frame. Slide the pivots into the
pivot slot on the mask frame (Fig. F-8).
Depress the forehead support tab and
move it into any of the tab positions.
11 Insert the headgear clips into the slots
on the mask frame. The headgear label
should face outwards and be near your
neck when fitted.
T S
ECHNICAL PECIFICATIONS
P –F
RESSURE LOW
See section A on the illustrations sheet.
D S I
EAD PACE NFORMATION
Dead space is the empty volume of the
mask up to the swivel.
The dead space of the mask varies
according to cushion sizes but is less than
258 mL.
Note: The manufacturer reserves the right
to change these specifications without notice.
R P
EPLACEMENT
Part No. Item
16604 Cushion, Small, Standard (1 pk.)
16671 Cushion, Small, Shallow (1 pk.)
16605 Cushion, Medium, Standard
(1 pk.)
16672 Cushion, Medium, Shallow
(1 pk.)
16606 Cushion, Large, Standard (1 pk.)
16673 Cushion, Large, Shallow (1 pk.)
16674 Cushion clip, Small (1 pk.)
16675 Cushion clip, Medium (1 pk.)
16676 Cushion clip, Large (1 pk.)
16613 Elbow assembly (1 pk.)
60683 Elbow retainer (1 pk.)
16509 Exhaust vent (1 pk.)
16510 Exhaust vent (10 pk.)
C
URVE
ARTS