Pinnacle Climate Remington REM-L180ALT-F Manual Del Usuario página 21

Log Placement— REM-L240CLR-F / REM-L240CNR-F
WARNING
CAUTION
contact with any log. If so, reposition the logs as indicated in the below illustrations. Yellow flames coming into
contact with logs create unnecessary soot.
Install the logs exactly as indicated (see Fig. 22–25). Do not
modify the logs, and use only logs supplied with the heater.
The logs are numbered and correspond to the numbers
listed below.
1. Place log #1 onto the pins in
the front grate base.
3. Place log #3 onto the back
grate base, making sure it's
aligned with logs #1 and 2.
©2017 Pinnacle Climate Technologies
Failure to position the parts in accordance with these diagrams or failure to use only parts
specifically approved with this heater may result in property damage or personal injury.
Check to ensure that no yellow flame comes in contact with any log, both after installation
and periodically afterwards. Set the heater to HIGH and check if yellow flames come into
Fig. 22
Fig. 24
2. Place log #2 onto the middle
grate base, making sure it's
aligned with log #1.
4. Place log #4 so that it's resting
on logs #1 and 2. Place log #5 so
that it's resting on logs #1, 2, and 3.
21 Vent-Free Gas Log Heater User Manual
Number of Logs: 5
Fig. 23
Fig. 25