Inserting The Batteries - Cardin Elettronica PRG850 BC Instrucciones Para La Instalación

INSERTING THE BATTERIES

Caution! The wires which connect the
batteries to the battery charger must
never be short circuited, this could
damage the batteries and in the worst
case could cause burns (if the contact is
made to metal parts which are touching
the skin).
• Connect the two batteries in series (fig.4.
Det. "D").
Attention: depending on the make of
battery used the positive and negative
poles "+" and "-" could be positioned
differently.
• Insert the batteries into the slots by
slightly bending the holding tabs "E"
upwards. Make sure that the fastons
remain visible after the insertion of the
batteries (towards the outside).
PREPARING THE WIRES
Attention! Make sure that the transformer
primary wire is disconnected.
Drawing number :
Product Code :
• Cut the four wires "F", coming from the
Draft :
transformer, near the fastons (fig. 5 det.
"G"):
CARDIN ELETTRONICA S.p.A - 31020 San Vendemiano (TV) Italy - via Raffaello, 36 Tel: 0438/401818 Fax: 0438/401831
- For PRG851: grey/grey (0-24Vac)
pink/red
- For PRG852: grey/grey (0-24Vac)
red/red (0-20Vac)
then strip the ends (fig. 5 det. "H").
• The faston of the fifth wire "secondary
2" (brown, 15V: for PRG851) or the fas-
tons of the two brown wires (0-15V: for
PRG852) coming from the transformer
must not be cut. They must be con-
nected directly to the transformer.
All rights reserved. Unauthorised copying or use of the information contained in this document is punishable by law
DM0476
PRG851
P.J.Heath Date : 02-03-2000
8
Drawing number :
DM0470
Product Code : PRG851
Date :
Draft : P.J.Heath
CARDIN ELETTRONICA S.p.A - 31020 San Vendemiano (TV) Italy - via Raffaello, 36 Tel: 0438/401818 Fax: 0438/401831
E
D
Description : Montaggio CARICA BATTERIA
FIG.4 (senza contenitore)
F
Montaggio CARICA BATTERIA
Description :
FIG.3
02-02-2000
4
5
5
H
G