Home Decorators Collection 7984HDCAN Guía De Uso Y Cuidado página 8

Assembly - Hanging the Fan
1
Attaching the fan to the electrical
box
WARNING: To reduce the risk of fire, electric shock or personal
injury, mount to outlet box marked "Acceptable for fan support
of 35 lbs. 15.9 kg) or less", and use screws provided with the
outlet box.
NOTE: The mounting bracket (A) is designed to slide into place
on an outlet box with the outlet box screws (KK) installed.
□
Loosen the two mounting screws (KK) in the outlet box.
□
Pass the 120-Volt supply wires through the center hole in the
mounting bracket (A).
□
Install the slide-on mounting bracket (A) on the outlet box by
sliding the slide-on mounting bracket (A) over the two screws
(KK) provided with the outlet box. If necessary, use leveling
washers (not included) between the slide-on mounting bracket
(A) and the outlet box. The flat side of the slide-on mounting
bracket (A) should face toward the outlet box, as shown.
□
Securely tighten the two screws on the electrical box.
KK
2
□
□
□
KK
A
8
Hanging the fan
Carefully lift the fan-motor assembly (E) up to the slide-on
mounting bracket (A).
Insert the ball portion of the ball/downrod assembly (B)
into the socket of the slide-on mounting bracket (A).
Turn the ball/downrod assembly (B) clockwise until it is
seated with the tab of the slide-on mounting bracket (A)
aligned with the slot in the ball.
A
C
B
D
E