Installation - Klarstein 10030272 Manual De Instrucciones

burning gas or other fuels. Regulations regarding air extraction must be complied with.
• Before connecting the hood: switch off the electricity supply and check that the supplied voltage and
frequency coincide with that indicated on the appliance nameplate.
• The hood may stop working during an electrostatic discharge (e.g. lightning). This involves no risk of
damage. Switch off the electricity supply to the hood and reconnect after one minute.
• Do not use the hood if it shows signs of damage or imperfection. Contact customer services.

INSTALLATION

Models without glass (10030272)
1. The cooker hood should be placed at a distance of 65-75cm (26-30inch) from the cooking surface for the
best effect. See Pic 1.
2. Install the hook on a suitable place once the installation height is
fixed, and keep it in line. The fixed position of the inside chimney
bracket is the place of chimney.
3. Fix the outside chimney bracket on the outside chimney, and be
sure that the inside chimney can be adjusted the height in it freely
as well as fixing the extensible pipe. Afterwards, install the exten-
sible pipe and chimney on the cooker hood. See Pic 3.
4. Put the cooker hood on the hook. See Pic 4.
5. Adjust the height of the inside chimney to the position of the
inside chimney bracket and fix on it by screw,after ajusting the
position,fix the body with safety screw. See Pic 5.
Note: The two safety vents are positioned on the back casing, with di-
ameter of 6mm.
20