Installation Steps - MacNeil WeatherTech Easy-On Instrucciones De Instalación

Installation Steps

Align hood shield with holes in hood. If equipped with rub-
ber trim on hood edges, the hood shield slides UNDER the
rubber trim pieces.
3
If (4) holes are present, remove the hood shield from hood,
and completely remove the preinstalled tape strips from both
outboard flanges of the hood shield.
COMPLETELY REMOVE TAPE
5
If (2) holes are present, remove the hood shield from
hood, and clean the mounting location on the hood with
an alcohol pad. Peel back 2" (5 cm) of tape liner off all
tape strips on outboard flanges to expose adhesive. Fold
free ends over so they will be accessible.
7
Remove remaining tape liner by pulling on free ends,
and apply pressure to adhere tape.
9
NOTE: Actual application may vary slightly from illustrations.
Free Ends
When aligning hood shield with hood, take note as to whether your
vehicle has (2) or (4) pre existing holes in the hood that will align
with the holes in the hood shield. If (4) holes proceed to step 5. If
(2) holes proceed to step 7.
4
Replace the hood shield on the hood, align holes, and
secure the hood shield to the hood with (4) fasteners.
6
Place hood shield on hood, and align with (2) inboard
holes. Install (2) fasteners in inboard holes to secure
8
Optional Screw Attachment
10
Hood Hood shield Washer
Page 2 of 3
Proceed to step 12.
DO NOT OVER TIGHTEN
the hood shield in place.
DO NOT OVER TIGHTEN
Do No Overtigthen