Appendix Ii - Worksheet - RIDGID RT1000 Manual De Instrucciones

RT1000 Tapping Tool
Appendix II – Worksheet
Pipe Identification Code Marking
Media
Pressure
Actual Pipe Type and Size
Identified By
Saddle or Thread-O-Let™ Manufacturer
Part Number
Designed Saddle Pipe Type & Size
(Must match pipe data above)
Designed Saddle or Thread-o-let™ Pressure Rating
(Must exceed main pressure)
Outlet Size
Installed/Welded Date
Installed/Welded By
Inspected Date
Saddle or Thread-O-Let™ Installation Approved By
Valve Manufacturer
Part Number
Valve Type & Size
Valve Pressure Rating (Must exceed main pressure)
Valve Approved By
Datum Offset (Figure 5)
Datum to Full Stroke (Figure 9)
Subtract "Datum Offset" from "Datum to Full Stroke" for
"Full Stroke Distance"
Valve Standoff Distance (Figure 10) (Note if Full Stroke
Distance – 1" = Valve Standoff Distance then ABORT
THIS TAP!)
Maximum Stroke (Figure 10) (Note if Maximum Stroke is
less than Full Stroke Distance be warned that penetration
of the back of the pipe is possible! Observe Unusable
Stroke Remainder (see Figure 12) to execute this tap
safely!)
12 Ridge Tool Company