Tripp-Lite U224-1R4-R El Manual Del Propietario página 5

Installation
Connect the local unit to a computer using the built-in USB cable.
1
• U224-1R4-R – No LEDs illuminate at this point.
• U224-4R4-R – The Red LED on the local unit illuminates to
(U224-1R4-R only) Connect the external power supply to the local
2
unit, and then plug it into a Tripp Lite Surge Suppressor, Power
Distribution Unit (PDU) or Uninterruptible Power Supply (UPS).
Using Cat5e/6 cable, connect the RJ45 ports on the local and
3
remote units.
• U224-1R4-R – The Red LED on the remote unit illuminates to
• U224-4R4-R – No additional LEDs illuminate at this point.
4 (U224-4R4-R only) Connect the external power supply to the remote
unit, and then plug it into a Tripp Lite Surge Suppressor, Power
Distribution Unit (PDU), or Uninterruptible Power Supply (UPS).
• U224-4R4-R – The Red LED on the remote unit illuminates to
Connect a USB device to an available port on the local and/or remote
5
units. Note: Remote ports support USB 2.0 devices at USB 1.1 speeds.
• U224-1R4-R – On the local unit, the Green LEDs next to the USB
• U224-4R4-R – On the remote unit, the Green LEDs next to the
Repeat step 5 for each additional USB device you wish to connect.
6
1111079 93-2836.indb 5
indicate it is receiving power from the computer's USB port.
indicate it is connected to the local unit.
indicate it is receiving power from the external power supply.
ports illuminate to indicate a USB device is connected, and
the Red LED in between the power and RJ45 jacks illuminates to
indicate a USB device is connected to the remote unit.
USB ports illuminate to indicate a USB device is connected.
5
12/2/2011 4:55:55 P