Pfeiffer Vacuum TPG 36X Instrucciones De Instalación página 4

EN
Desk-Top Unit
4
55.9
M3 oder ø3.5
Fig. 2: For mounting the unit into a control panel, this cut-out is required
Fig. 3: Installing the TPG 36x in a control cabinet
 Slide the TPG 36x into the cut-out of the control panel and secure it with four M3 or
equivalent screws.
– For reducing the mechanical strain on the front panel, preferably support the unit.
The TPG 36x is also suited for use as desk-top unit. For this purpose, two self-adhesive
rubber feet as well as a slip-on rubber bar are supplied with it.
Thermal overload!
 Set up the unit so that the admissible maximum ambient temperature (e. g. due to
installation or sunlight) is not exceeded.
 Ensure adequate air circulation!
70
NOTICE