Dyna-Glo DGX780BDC-D Manual Del Usuario página 8

ASSEMBLY INSTRUCTIONS
5. Position the square smoke stack (A) with control
arm to the left as shown. Using four M6x12
screws (AA), attach square smoke stack (A) to
the top of smoker body (G). Securely tighten with
a Phillips screwdriver.
Hardware Used
AA M6 x 12mm
Screw
6. Insert the wood chip box supports (R) into the
bottom holes inside the smoker body (G). Repeat
this process for the cooking grate supports (F) on
each side, inserting from lower positions to
higher positions.
NOTE: There are 8 positions to install the cooking
grate supports, according to the need of the owner.
x 4
8
5
A
G
6
AA
G
F
R
F