Installing The Radio In The U-Bracket - Tait TM8100 Guía Del Usario

Installing the
Radio in the
U-bracket
26 Radio Installation
3. Cut the negative and the positive wires where the in-
line fuse holders will be placed (as close to the
battery as possible).
Note: Do not install the fuses until the
installation is ready to be checked.
4. Insert each end of the negative wire into one of the
in-line fuse holders and crimp them to force the
metal contacts onto the wires.
5. Connect the negative wire to the battery ground.
6. Repeat step 4 for the positive wire and connect it to
the positive terminal of the battery.
1. Connect the antenna and power cables to the rear of
the radio.
2. Position the radio in the U-bracket so that the
holes in the U-bracket line up with the holes in the
radio chassis.
3. Screw the radio into position using the four thumb
screws but without fully tightening the screws.
4. Position the radio in the U-bracket for best viewing
angle, then tighten the thumb screws.