Garden Treasures SC-GSN-V1 Manual De Instrucciones página 6

ASSEMBLY INSTRUCTIONS
5. Align the assembled back crossbar with the
hole in the lower back legs. For each hole
insert an M6 x 65 mm bolt (BB) through an
M6 washer (HH), through the back legs
and into the back crossbar. Do not tighten
completely. Now go back and securely
tighten all nuts and bolts.
Hardware Used
BB
M6 x 65 mm Bolt
AA
HH M6 Washer
AA
Seat Assembly
6. Lay out the right seat arm (G), left seat arm
(H), and seat supports (I). Make sure that
the labels marked "Front" on the arms are
all facing the front edge of the seat.
Connect the arms to the seat supports by
sliding the tabs on the ends of the seat
supports (I) down into the brackets on the
arms (G & H). Make sure they are securely
seated.
7. Open the seat assembly (J) and lay it on
top of the frame from step 6, lining up the
holes in the seat arms (G & H) with the
holes in the side tubes of (J). Insert an M8
x 80 mm bolt (EE) from outside through the
arm holes, through a plastic washer (JJ),
through the side bar on the seat assembly,
through an M8 washer (II) and an M8 nut
(GG). Don't tighten completely. Repeat
procedure on the other side. Then securely
tighten the bolts and nuts.
Hardware Used
EE
M8 x 80 mm Bolt
AA
GG
M8 Nut
AA
I I
AA
M8 Washer
JJ
AA
Plastic Nut
5
x 2
BB
x 2
HH
6
G
7
x 2
x 2
J
x 2
x 2
6
C
F
I
H
II
GG
G
Lowes.com/gardentreasures
C
E
JJ
J
EE
H