BLACK&DECKER LST1018 Manual De Instrucciones página 10

• Insert the inch (19mm) screw
3 /4
as shown in figure F to complete
the guard assembly.
TO ATTACH:
• Place the assembled guard over
the spool as shown in figure G
and insert the remaining three
screws into the guard as
indicated by the arrows.
• Once the guard is installed,
remove the covering from the line
cut-off blade, located on the edge
of the second guard section.
F
G
Push the auxillary handle onto the upper
AuxilIary handle attachment
tube. Position the handle so that the groove
in the tube is located in the middle of the
handle opening. Insert the handle bolt
through the hole in the handle as shown in
figure H and I.
AUXILIARY HANDLE ADJUSTMENT
For maximum comfort and control,
adjust the auxiliary handle to suit
your height (figure J). Shorter users
adjust handle to a lower position
(away from you) and taller users,
adjust handle to an upper position
(towards you). The handle should be
adjusted so that your front arm is
straight as shown in figure M.
10
H
I
J