Home Decorators Collection 59256 Guía De Uso Y Mantenimiento página 10

Assembly - Hanging the Fan (continued)
4
Wrapping the extra wire
NOTE: Follow this step ONLY if you did not cut the extra length off
from the wires coming from the ceiling fan.
□
Gently wrap the excess wire around the mounting bracket (A).
□
Secure with electrical tape.
A
5
Mounting the fan-motor assembly
(standard mount)
WARNING: When using the standard ball/downrod
mounting, the tab in the ring at the bottom of the
mounting bracket must rest in the groove of the hanger
ball. Failure to properly seat the tab in the groove could
cause damage to the wiring.
NOTE: The magnet is pre-attached on the canopy
bottom cover for you to remove and install easily.
□
Align the locking slots of the canopy (C) with the two screws
(CC) and alignment post (KK) in the mounting bracket (A).
□
Push up the canopy (C) and turn clockwise until the alignment
post (KK) engages to the round hole and the screws (CC)
engage to the key slots.
□
Firmly tighten the two mounting screws (CC).
□
Align the oval shape on the canopy (C) with the canopy bottom
cover (DD). Push up the canopy bottom cover (DD) until the
screw (CC) heads engage to the slots on the canopy bottom
cover (DD) so that the magnetic canopy bottom cover (DD) can
be attached to the bottom of the canopy (C) properly.
KK
10
A
CC
C
DD
D
E