Home Decorators Collection 59256 Guía De Uso Y Mantenimiento página 7

Assembly - Standard Ceiling Mount
1
Preparing for mounting
NOTE: The magnet is pre-attached on the canopy
bottom cover for you to remove and install easily.
□
Pull off the canopy bottom cover (DD) from the canopy (C).
□
Loosen the two canopy screws (CC) located in the
bottom of the mounting bracket (A), and turn the canopy
counterclockwise to remove the mounting bracket (A) from
canopy (C).
3
Assembling the fan
CAUTION: To ensure wobble-free operation and to avoid
damage to the fan, the downrod (B) and the setscrew
(EE) must be completely tightened.
NOTE: This fan is equipped with a safety tab (GG).
Should the setscrew (EE) ever become loose while
the fan is running in reverse, the safety tab (GG) will
engage and stop the fan from falling.
□
Loosen, but do not remove, the setscrew (EE) on the collar (FF)
on top of the fan-motor assembly (E).
□
Install the downrod (B) by inserting it into the motor collar (FF),
and turning it clockwise until it is tight.
□
Re-tighten the setscrew (EE) on the collar (FF) on top of the fan-
motor assembly (E).
2
A
CC
C
DD
7
Routing the wires
□
Route the wires exiting the top of the fan motor
assembly (E) through the decorative motor collar cover
(D) and then the center of the canopy bottom cover
(DD).
□
Make sure the opening of canopy (C) is on top and
insert the ball/downrod (B) through the canopy (C).
□
Route the wires exiting the top of the fan motor
assembly (E) through downrod as shown.
EE
HOMEDEPOT.COM/HOMEDECORATORS
Please contact 1-800-986-3460 for further assistance.
C
DD
D
B
E
B
FF
GG
E