Kohler K-T7019 Guia De Instalacion página 5

Spout Supply
Tube
Spout
Sleeve
Assembly
3. Install the Spout
NOTICE: To avoid damage to the seal in the base of the spout, use
care when installing the spout.
NOTICE: To avoid damage to the O-ring on the spout sleeve
assembly, keep the spout supply tube clean and use care when
installing the spout.
Loosen the setscrew until it is clear of the inside wall of the
spout.
Apply a ring of plumbers putty or other sealant around the
underside of the spout according to the sealant manufacturer's
instructions.
Position the spout on the spout sleeve assembly, then carefully
press down until the spout contacts the finished surface.
Rotate the spout until it is aligned to face straight forward.
Retighten the setscrew.
Insert the plug button over the setscrew so it is flush with the
surface of the spout.
Remove any excess putty or sealant.
Kohler Co.
Setscrew
Plug Button
O-Ring
5 1011303-2-C