NORTH STATES 4940 Manual De Instrucciones página 5

Figure 7
Figure 8A
8B
Step 4: Position the template vertical to the floor and
mark the screw holes. Mount the wall fittings A, B, C
onto the wall with screws included.
Figure 9A
Step 6: Place panels on the mounted wall
fittings, as shown in Figure 12A and 12B.
Step 3: On the end panels, remove the vertical
bars.
Turn clockwise to loosen the vertical bar, then
pull down to remove.
Note: To reposition the panel with the door,
simply follow the directions to set up the
Superyard as an enclosure. Select and
disconnect the two panels you desire to mount
to the wall or surface.
8D
8C
9B
Step 5: Attach floor spacer-D to lower
hinge housing.
9C
Step 7: Insert removable bars through wall
fitting-C on both sides of gate, positioning the
bars in lower hinge housing.
Page 5
8E
9A