Installing Your Unit - Impecca IWA15-QS30 Manual De Usuario

TOOLS
• Philips screwdriver
• Flat-head screwdriver
• Pencil
Note:
• Always contact a local, qualified professional for installation.
• Never use an underrated electrical cord or outlet!
WEATHER-PROOF WINDOW MODIFICATIONS
If you have weather proof windows, the exterior window frame will be slightly higher
than the window sill, which results in a slanted air conditioning unit that will not properly
drain. Perform these modifications to ensure proper operation of your unit. If you have a
standard window, skip this step.
1. Cut a 2" thick piece of wood to the length of the the interior window width.
2. Verify that the wood is level with or up to 0.5" (1cm) higher than the exterior weath-
erproof frame.
3. Fasten the wood with screws to the windows sill and proceed with mounting.

INSTALLING YOUR UNIT

STEP 1: REMOVING OUTER CASE
1. Hold the two tabs on the right and left side of the panel. Gently pull outward on
the cover, then lift the panel cover up to remove. Remove the filter after taking off
the cover.
2. Remove the four screws on the front case and keep them in a safe place. Gently
remove the front panel housing by pulling out the bottom of the frame and then
lifting upward.
3. Remove the two screws on the control panel cover.
• Scissors
• Level
• Measuring tape
–12–