Installation Steps; Care And Cleaning - AVS Ventshade Deflector Instrucciones De Instalación

Installation Steps

Insert lateral flange of visor between door weatherstripping and
door frame, starting at the curve first.
3
Holding visor in place, drill (2) 5/64" holes in door
frame, using holes in clips as guides.
Drill
5
Reinstall rubber window channel. Raise window carefully to de-
termine any interference. Clean and polish the visor using a soft
cloth and metal polish.
7

Care and Cleaning

• Wash only with mild soap & dry with a clean cloth.
Congratulations!
You have purchased one of the many quality Auto Ventshade™ branded products offered by Lund International, Inc. We take the utmost pride in our
products and want you to enjoy years of satisfaction from your investment. We have made every effort to ensure that your product is top quality in
terms of fit, durability, finish and ease of installation.
™ Auto Ventshade
NOTE: Actual application may vary slightly from illustrations.
Drill
Lund International
800-241-7219 • Visit us at lundinternational.com
© 2012 Lund International, Inc. All rights reserved.
, the Auto Ventshade logo and the AVS
TM TM
Place end flange between door weatherstripping and division bar as
shown. Clip tabs should be on outside of door frame as shown.
clip tabs
4
Install screw provided. DO NOT substitute scew.
6
Repeat Steps 1-7 for opposite side
logo are trademarks of Lund International, Inc.
TM
Page 2 of 2
lateral flange
clip tabs