THERMEx PRO LINK II Serie Instrucciones página 69

M 536991501911122018
7
x4 x4
Mount the cover on the plastic box contain-
ing the transceiver using 4 screws. Mount
the plastic plugs on the screws.
INSTALLING THE TRANCIEVER ON WALL-MOUNTED LYON
The electronics on the wall-mounted Lyon are located on top of the hood. The transceiver is installed as follows:
1
Remove the plastic cap from the connector on
the circuit board box. This easiest way to do this
is to use a screwdriver or similar tool to gently
coax the cap off.
4
Mount the connector from the control panel on
the transceiver.
8
Mount the box containing the transceiver in
a suitable fixed position inside the hood. Use
the double adhesive tape supplied for this.
NOTE: Be sure to wipe the surface thoroughly
with alcohol before mounting the transceiver
in its fixed position.
2
Remove the connector from the control panel of
the circuit board.
5
x4
x4
Mount the cover on the plastic box containing
the transceiver using 4 screws. Mount the plas-
tic plugs on the screws.
THERMEX PRO LINK II
9
Place the filters in the hood and close the
cover.
3
Mount the connector from the transceiver on
the hood's circuit board and replace the plastic
cap.
6
Mount the box containing the transceiver in a
suitable fixed position inside the hood. Use the
double adhesive tape supplied for this.
NOTE: Be sure to wipe the surface thoroughly
with alcohol before mounting the transceiver in
its fixed position.
69