Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
NOTE: This step is applicable after the necessary wiring
is completed.
▲WARNING
To avoid possible fire or shock, make sure that the
electrical wires are completely inside the canopy housing
and not pinched between the housing and the ceiling.
1. Remove one of the two shoulder screws in the
hanger bracket. Loosen the second shoulder screw
without fully removing it. Assemble canopy by
rotating key slot in canopy over shoulder screw in
hanger bracket. Tighten shoulder screw. Fully
assemble and tighten second shoulder screw that
was previously removed (Figure 1).
2. Securely attach and tighten the canopy screw cover
o
v
r e
h t
e
s
h
o
u
d l
r e
utilizing the keyslot twist-lock feature (Figure 2).
Installing the Canopy Housing
c s
e r
w
s
n i
h t
e
h
a
n
g
r e
b
a r
k c
t e
11
Figure 1
Figure 2
Publicidad
Capítulos
Tabla de contenido
Solución de problemas
