Proposition 65; Installation; Unpack The Machine; Unfold And Adjust The Lower Handle - GreenWorks MO09B01 Manual Del Operador

EN
SYM- SIGNAL
BOL
DANGER
WARNING
CAUTION
CAUTION
6

PROPOSITION 65

This product contains a chemical known to the state of
California to cause cancer, birth defects or other
reproductive harm. Some dust created by power sanding,
sawing, grinding, drilling, and other construction activities
contains chemicals known to cause cancer, birth defects or
other reproductive harm. Some examples of these chemicals
are:
• Lead from lead-based paints;
• Crystalline silica from bricks and cement and other
masonry products;
• Arsenic and chromium from chemically treated lumber.
Your risk of exposure to these chemicals varies depending
on how often you do this type of work. To reduce your
exposure to these chemicals, work in a well-ventilated area,
and work with approved safety equipment, such as dust
masks that are specially designed to filter out microscopic
particles.
Save these instructions.
7

INSTALLATION

Do not change or make accessories that are not
recommended by the manufacturer.
Do not connect the machine to the power supply until you
assemble all the parts.
MEANING
Indicates an imminently haz-
ardous situation,which, if not
avoided, will result in death
or serious injury.
Indicates a potentially hazard-
ous situation,which, if not
avoided, could result in death
or serious injury.
Indicates a potentially hazard-
ous situation, which, if not
avoided, may result in minor
or moderate injury.
(Without Safety Alert Sym-
bol) Indicates a situation that
may result in property dam-
age.
WARNING
WARNING
WARNING
English
7.1

UNPACK THE MACHINE

Make sure that you correctly assemble the machine before
use.
• If the parts have damage, do not use the machine.
• If you do not have all the parts, do not operate the
machine.
• If the parts are damaged or missing, speak to the service
center.
1. Open the package.
2. Read the documentation in the box.
3. Remove all the unassembled parts from the box.
4. Remove the machine from the box.
5. Discard the box and package in compliance with local
regulations.
7.2 UNFOLD AND ADJUST THE
LOWER HANDLE
10
9
1. Pull up and back the upper handle to lift the handle into
operation position. Make sure that the handles click into
position correctly.
2. Tighten the lower handle with the quick-release levers
(11) on the two sides.
Make sure that the two handles are in the same position.
Do not make damage to the cables when you fold or unfold
the handle.
8
WARNING
WARNING
11
NOTE
WARNING