Cleaning And Maintenance - HealthSmart Cube Mate Manual De Instrucciones

When water has reached the minimum fill level in the tank, the humidifier stops
automatically and the power refill indicator light will illuminate red.

Cleaning and Maintenance:

- Before cleaning the equipment, always turn the humidifier OFF, and disconnect the unit
from the adapter and plug from the power outlet.
- Do not place the humidifier directly under running water.
- Do not wet the adapter or air inlet.
- Do not scrape the ultrasonic transducer with metallic materials, tools or objects.
- Do not leave water in the water tank when the equipment is not in use.
Daily Cleaning:
Remove the tank cover from the base and slowly pour out all remaining water.
Clean the cover, tank and transducer of the humidifier with a soft, clean cloth and dry
thoroughly.
Dry all parts thoroughly before storage.
Weekly Cleaning:
Remove the tank cover from the base, and quickly pour out all remaining water.
Note: The unit is equipped with four drainage columns located on each inside corner of the unit.
When pouring out the water, it may flow into these columns, thus causing water to drain from the
bottom of the unit. It is recommended to always drain the water over a sink to avoid potential spills.
Pour a water solution prepared with 50% white vinegar into the water tank. Do not fill the
tank all the way to the brim.
Replace the tank cover and leave soak for at least 4 hours (overnight is ideal). Do NOT turn
the humidifier ON and run the unit with the water and vinegar cleaning solution.
Remove the tank cover and pour out all of the water/white vinegar solution, and rinse the
tank with cool, clean water.
5