Dual Mono / Bi-Amping - Arcam FMJ G CLASS P429 Manual De Instrucciones

HF
Remove
LF metal strip
1/2 MODE
ST/DM/BR
P429
Height 1 Right
1/2 MODE
ST/DM/BR
1/2 MODE
ST/DM/BR

Dual mono / Bi-Amping

Dual mono requires the use of two channels of the
P429 for each speaker, as shown in the diagram
below.
In this setup, only one interconnect is required for
each pair of channels. The L and R output of the two
channels of your audio/video device (such as the
Arcam 550/850) should be connected to the IN1 and
IN3 input of the P429, respectively.
CH4 CH3
4–16 OHMS. CLASS 2 WIRING
TRIGGER
IN
NET RS232 3/4 MODE
TRIM
ST/DM/BR
5V 100mA
4 3
TRIGGER
3/4 MODE
12V 100mA
ST/DM/BR
Make sure both MODE 3/4 MODE
switches are set to the
ST/DM/BR
DM position
3/4 MODE
ST/DM/BR
HEIGHT 1
L
R
WARNING: the strip of metal on the speakers connecting
the low frequency (LF) terminals to the high frequency (HF)
terminals MUST BE REMOVED. Failure to do so will result
in damage to both amplifiers, which will not normally be
covered under warranty.
CH2 CH1
IN4 IN3 IN2 IN1
1/2 MODE
TRIM
ST/DM/BR
2 1
Remove
metal strip
1/2 MODE
OUT4 OUT3 OUT2 OUT1
ST/DM/BR
1/2 MODE
ST/DM/BR
1/2 MODE
ST/DM/BR
HEIGHT 2
STB/MHL
Z2 OUT STB
HEIGHT 1 HEIGHT 2
L
R
PREAMP OUT
PREAMP OUT
FL SL
PREAMP OUT SUB 2
FR SR
E-11
HF
LF
3/4 MODE
ST/DM/BR
Height 1 Left
3/4 MODE
ST/DM/BR
3/4 MODE
ST/DM/BR
GAME AV SAT BD VCR PVR ZONE2 OUTPUT2 OUTPUT1
OUT ARC
HDMI DIGITAL AUDIO
GAME AV BD PVR CD SAT PVR
FM/DAB
ETHERNET
USB 5V / 1A DC6V
ANALOGUE AUDIO BD CD STB AV
1.2A MAX
COAXIAL OPTICAL
SPEAKER OUTPUTS
ZONE 2 R 8 LOAD IMPEDANCE RECOMMENDED ZONE 2 L
HEIGHT 1 R HEIGHT 1 L
SBR SR FR C FL SL SBL
SUB 2
C SBL
~ 50 – 60 Hz 1.5KW MAX
115 230
SBR SR FR C FL SL SBL
SUB SBR HEIGHT 1 R HEIGHT1 L
ZONE 2 R ZONE 2 L
AVR550/850
TRIG Z1 Z1 IR
RS232
TRIG Z2 Z2 IR