Wayne Dalton 8000 Manual Del Usuario página 19

Top Section Continued...
For quick install track:
Tools Needed:
Complete the vertical track installation by securing
the center jamb bracket(s) and tightening the other
lag screws. Repeat for opposite side.
For fully adjustable track:
Complete the vertical track installation by securing
the center jamb bracket(s) and tightening the other
lag screws. Push the vertical track against the rollers
so that the rollers are touching the deepest part of
the curved side of the track (see illustration); tighten
all the track bolts and nuts. Repeat for opposite side.
Repeat for opposite side.
16
Attaching Quick Install Flagangle
to Quick Install Horizontal Track
NOTE: If you have universal horizontal track, skip this
Tools Needed:
step and complete step 17.
9/16" Socket
Ratchet Wrench
To install horizontal track, place the curved end over
9/16" Wrench
the top roller. Align key slot of the horizontal track
with the quick install tab of the flagangle. Push
Level
curved portion of horizontal track down to lock in
Hammer
place.
Step Ladder
WARNING
DO NOT RAISE DOOR UNTIL HORIZONTAL TRACKS
ARE SE CURED AT REAR, AS OUTLINED IN STEP 29,
OR DOOR COULD FALL FROM OVERHEAD POSITION
CAUSING SEVERE OR FATAL INJURY.
Level the horizontal track assembly and bolt the
horizontal angle to the slot in the flagangle using (1)
3/8"- 16 x 3/4" truss head bolt and (1) 3/8"- 16 hex
nut. Repeat for other side. Remove the nail that was
temporarily holding the top section in place, installed
in Step 15.
IMPORTANT: Failure to remove nail before attempting
to raise door could cause permanent damage to top
section.
NOTE: If an idrive
horizontal tracks slightly above level.
NOTE: After completing this step, continue with Step
18.
Please Do Not Return This Product To The Store. Contact your local Wayne Dalton dealer. To find your local Wayne Dalton dealer, refer to your local
yellow pages business listings or go to the Find a Dealer section online at www.Wayne-Dalton.com.
® opener will be installed, position
Nail
Top section
1-11/16" To 1-3/4"
Top section
Quick install
Quick
flagangle
install
horizontal
track
Key slot
Quick install tab
Quick install
vertical track
(1) 3/8"- 16
Hex nut
Vertical track
Roller
Roller against
vertical track
Flagangle
Quick install
Quick
flagangle
install
horizontal
track
Key slot
Quick install
tab
Quick install
vertical track
Flagangle
(1) 3/8"- 16 X 3/4"
Truss head bolt
Horizontal angle
19