Wayne Dalton 8000 Manual Del Usuario página 22

19
Ratchet Wrench
Tools Needed:
1/2" Socket
KEEP HORIZONTAL TRACK
1/2" Wrench
PARALLEL AND WITHIN 3/4"
(2) Vice Clamps
MAXIMUM OF DOOR EDGE,
OTHERWISE DOOR COULD
Tape Measure
FALL FROM THE HORIZONTAL
Level
POSITION, RESULTING IN SEVERE
Hammer
INJURY OR DEATH.
Step ladder
Raise the door until the top section
and half of the next section are in a
horizontal position. Do not raise door any
further since the horizontal tracks are
not yet supported at the rear.
RAISING DOOR FURTHER CAN
RESULT IN DOOR FALLING AND
CAUSE SEVERE OR FATAL INJURY.
Clamp a pair of vice clamps on each of
the vertical tracks just below the bottom
roller on both sides of the door. This will
prevent the door from lowering while
installing the rear support.
Using perforated angle,
5/16" x 1-5/8" hex head lag screws
and 5/16" bolts with nuts (may not be
supplied), fabricate rear supports for
horizontal tracks.
Attach horizontal tracks to the rear
supports with 5/16"-18 x 1-1/4" hex
bolts and nuts (may not be supplied).
The bolt should extend into the track
to act as a roller stop. Horizontal tracks
must be level and parallel with door.
NOTE: If rear supports are to be installed
over drywall, use 5/16" x 2" hex head
lag screws.
WARNING
REAR SUPPORTS MUST BE
SECURELY ATTACHED TO SOUND
FRAMING MEMBERS, OR DOOR
COULD FALL FROM HORIZONTAL
POSITION, RESULTING IN SEVERE
OR FATAL INJURY.
22
Please Do Not Return This Product To The Store. Contact your local Wayne Dalton dealer. To find your local Wayne Dalton dealer, refer to your local
yellow pages business listings or go to the Find a Dealer section online at www.Wayne-Dalton.com.
Rear Supports
WARNING
WARNING
PERFORATED ANGLE
(3) 5/16"
BOLTS & NUTS
SOUND FRAMING MEMBERS
ANGLE BRACE
HORIZONTAL TRACK
SOUND FRAMING MEMBERS
ANGLE BRACE
HORIZONTAL TRACK
DOOR IN THE
UP POSITION
VERTICAL
TRACK
VICE
CLAMPS
HORIZONTAL
TRACK
DOOR EDGE
3/4"
MAX
PERFORATED ANGLE -BOLTED
USING (2) 5/16" X 1-5/8"
HEX HEAD LAG SCREWS TO
CEILING MEMBER
BOLT MUST EXTEND INTO
THE TRACK TO SERVE AS
A ROLLER STOP
PERFORATED ANGLE -BOLTED
USING (2) 5/16" X 1-5/8"
HEX HEAD LAG SCREWS TO
CEILING MEMBER