Publicidad
5
INSTALL TOWERS ONTO LANDING PADS
• Using your tower instructions as a reference, carefully place the assembled crossbars with
towers onto the Landing Pads.
• Center the crossbars and fully close your SkyLine towers or fully torque your Control towers to
the crossbars according to the tower instructions.
6
Continue with
your SkyLine or
Control Towers
installation.
READ THESE WARNINGS!
• Make sure your SkyLine™ or Control Towers™
with bars installed seat completely with Landing
Pad™. If they do not seat properly, repeat step 5.
• Be sure all hardware is secured according to the
instructions. Failure to perform safety checks
before driving away can result in property
damage, personal injury, or death.
• Attachment hardware can loosen over time.
Check and tighten if necessary, before each use.
• To avoid damage to your vehicle's finish remove
and clean the Landing Pads and mounting
points periodically as road sediment will
accumulate over time.
Instruction #1036080A - Page 3 of 6
7
INSTALL THE COVERS WHEN THE RACK IS NOT ATTACHED.
Using the covers will
help keep the bases
free of debris.
.
™
MAXIMUM WEIGHT LIMIT
To review your vehicle's specific weight limit and load
limitations for accessories, visit yakimatech.com.
For additional product support, visit yakima.com/
support or contact us directly at (888)925-4621
Monday through Friday, 7:00 AM to 4:00 PM, PST.
Remove your YAKIMA rack and accessories
before entering automatic car washes.
DO NOT EXCEED THE
FOR YOUR VEHICLE.
2X
2X
4X
4X
Publicidad
