Tabla de contenido
Publicidad
BRAVE
GENERAL SAFETY
1.
Before operating this machine, read and observe all safety, unpacking, and operating
instructions. Failure to comply with these instructions could create a hazardous situation.
2.
The operator of this equipment should not operate this equipment when fatigued or under
influence of alcohol or drugs.
3.
The operator of this equipment should be thoroughly familiar with its operation and trained
in the job to be accomplished.
4.
The operator of this equipment should wear protective face shields and other protective
clothing as required for safe operations. To reduce the risk of injury, keep children and
visitors away.
5.
Dress properly. Do not wear loose clothing, gloves, neckties, or jewelry. They can
get caught and draw you into moving parts. Rubber gloves and nonskid footwear are
recommended when working outdoors. Also wear protective hair covering to contain long
hair.
6.
Do not leave this machine unattended when it is operating.
7.
All installations must conform to all applicable local codes. Contact your electrician,
plumber, utility company or seller for details.
8.
Follow instructions on how to stop the machine and bleed pressures quickly. Be thoroughly
familiar with the controls.
9.
Do not operate the machine if any mechanical failure is noted or suspected.
10. When starting a job, survey the area for possible hazards and correct before proceeding.
11. Keep all protective covers and shields in place. Replace all protective covers and shields
after adjustments are made to prevent accidental contact with hazardous parts.
12. If a water or fuel leak is found, DO NOT OPERATE THE MACHINE. Shut off and repair.
13. Inspect machine for damaged or worn components and repair or replace to avoid potential
hazards. Do not operate the machine if any mechanical failure is noted or suspected.
14. If chemicals are used in conjunction with this equipment, read and follow the product label
directions.
15. Always point the gun assembly in a safe direction away from people and do not direct
spray on the cleaner.
ELECTRIC MOTOR SAFETY
1.
This machine must be electrically grounded. Failure to have the machine grounded may
result in the operator being electrically shocked and even death.
2.
Fuses or circuit breakers should be compatible with machine requirements.
3.
If an extension cord must be used to operate this machine, it should be as short as
possible. The extension cord must be properly sized and fitted with a grounding type plug
and receptacle.
4.
Do not plug–in or un–plug machine with wet hands.
5.
Keep power cords and connections (connectors) out of water.
6.
All wiring and electrical connections should comply with the National Electrical Code (NEC)
and with local codes and practices.
7.
High voltage may be present within this machine. Servicing should only be performed by
properly trained personnel.
8.
This product is provided with a ground fault circuit interrupter built into the power cord plug.
If replacement of the plug or cord is needed, use only identical replacement parts.
Specifications
6
800-350-8739
www.braveproducts.com
Publicidad
Tabla de contenido
