Section 2. General Description; Introduction; Description; Section 3. Installation - Jandy Stealth SHPF Manual De Instalación Y Funcionamiento

Page 6
ENGLISH
Listed/certified to latest
published version of
ANSI
A112.19.8 - 2007,
or its successor standard,
ANSI/APSP-16,
Anti-entrapment
Cover/Grate or Suction
Fitting, screw-fastened
to Main Drain Sump
Suction Outlet
(Main Drain)
Figure 1. Number of Suction Outlets Per Pump

Section 2. General Description

2.1

Introduction

This manual contains information for the proper
installation, operation and maintenance of Jandy
Stealth (SHP) Pumps. Procedures in this manual must
be followed exactly. To obtain additional copies of
this manual contact Zodiac Pool Systems LLC at
800.822.7933. For address information, see the back
cover of this manual.
2.2

Description

Jandy SHP Pumps are designed to meet the needs of
today's more hydraulically demanding pool equipment.
The pump housing, backplate, diffuser, hair and lint
pot (pump debris filter basket), and impeller are all
made from high quality thermoplastic materials. These
materials were chosen for their strength and corrosion
resistance.
The pump is driven by an electric motor directly
attached to the pump impeller. As the electric motor
turns, it causes the impeller to turn, which forces water
to flow through the pump. The water flows through the
pump inlet and then into the filter basket. The basket
assembly pre-strains and traps large particles. The
water then enters the center of the pump housing, flows
through the impeller into the diffuser, and then flows out
the pump discharge port.
Jandy Stealth
®
three (3) feet
® /ASME
No valves between
Tee and Main Drains
Valves OK between
pump and Tee
|
Pumps Operation Manual
™
At least
Listed/certified to latest
published version of
or its successor standard,
Cover/Grate or Suction
Fitting, screw-fastened
to Main Drain Sump

Section 3. Installation

3.1

Plumbing

3.1.1 Preparation
1. Upon receipt of the pump, check the carton for
damage. Open the carton and check the pump
for concealed damage, such as cracks, dents
or a bent base. If damage is found, contact the
shipper or distributor where you purchased the
pump.
2. Inspect the contents of the carton and verify
that all the parts are included. See Section 7.1,
Replacement Parts List.
3.1.2

Pump Location

To Reduce the Risk of Fire, install pool equipment in
an area where leaves or other debris will not collect
on or around the equipment. Keep surrounding area
clear of all debris such as paper, leaves, pine-needles
and other combustible materials.
1. Zodiac Pool Systems LLC recommends
installing the pump within one (1) foot above
the water level. The pump should not be
elevated more than a few feet above the water
level of the pool. A check valve is recommended
on the suction line to the pump.
ANSI/ASME
A112.19.8 - 2007,
ANSI/APSP-16,
Anti-entrapment
Suction Outlet
(Main Drain)
Pump
WARNING