Plextor PX-850 Manual De Instalación Y Usuario página 36

Section 2. Installing the PX-850A Internal PATA Drive
Figure 13: Removing the cover panel from a bay
4. Determine if you must install mounting rails on the sides of your
drive. To do so, insert the drive into the open bay. If the drive fits
tightly with little or no clearance on either side of the drive, you will
not have to use mounting rails. The drive can be mounted directly
into your computer. Go to step 6.
NOTE: Plextor does not provide rails. If you need rails, you can
obtain them from the computer manufacturer or from a computer
supply retail or mail-order store.
5. If you must use mounting rails, fasten the rails to the lower pair of
holes as shown in Figure 14. (In some instances, you may need to
fasten the rails to the upper set of holes.) After fastening the rails,
check their positioning by sliding the drive into the bay before you
mount the drive or connect any cables.
CAUTION: Be sure not to mistake the inner and outer face of the rail
when attaching. Typically, the smooth side of the rail faces away from
the drive's chassis.
28
PX-850 Installation and Users Manual