PRASTEL EASYKA Manual Del Usuario página 38

ENGLISH ISEASYKA_07_06.doc
EASYKA - EASYBKA
8. Programming the EASYKA
Programming the EASYKA is done solely via the unit's keypad driven
Programming Menu System (see par.8.1).Certain codes and settings
are pre-programmed with Default Factory Settings. The table below
shows the names of all the EASYKA Menus, default factory codes and
settings.
The keypad accepts as default a 4-digit sequence and in the same
manner, the access code for programming functions is of 4 digits
(default 1234).
The number of digits can be increased to 5, 6 or 8 digits. This
modification is made using menu "0", after having entered the
programming mode (see paragraph 23).
ATTENTION: this programming must be done at the time of
installation because passing from one length to another cancels
all the memory content.
When the code length is modified, the programming access code
(initially 1234) is modified as shown in the following table (see
paragraph 8):
38