Wall Control Operation; Testing Your Fan - Craftmade Stellar Guia De Instalacion

11. Wall Control Operation.

The wall control is operational for fan
light (dimmer).

12. Testing Your Fan.

It is recommended that you test fan before
finalizing installation. Slide the knobs to OFF
position on wall control. Restore power from
circuit box. Test light and dimmer function
and then test fan speeds. If fan and/or light
do (does) not function, please refer to
"Troubleshooting" section to solve any issues
before contacting Customer Service.
Turn fan completely off before moving the
reverse switch. Set reverse switch to
recirculate air depending on the season:
- LEFT position in summer (diagram 1)
- RIGHT position in winter (diagram 2)
A ceiling fan will allow you to raise your
thermostat setting in summer and lower your
thermostat setting in winter without feeling a
difference in your comfort.
Important: Reverse switch must be set either
completely LEFT or completely RIGHT for fan to
function. If the reverse switch is set in the
middle position (diagram 3), fan will not
operate.
and
Move slide knob
up or down for
LIGHT brightness
reverse switch
diagram 1
page 9
LOW speed
MEDIUM LOW speed
MEDIUM speed
HIGH speed
turns fan OFF
motor housing
reverse switch
diagram 2
diagram 3