IT IS HAZARDOUS FOR ANYONE OTHER THAN AUTHORISED
SERVICE PERSONNEL TO CARRY OUT SERVICING OR REPAIRS
WHICH INVOLVE THE REMOVAL OF COVERS.
TO AVOID THE RISK OF AN ELECTRICAL SHOCK DO NOT ATTEMPT
REPAIRS YOURSELF.
2. INSTALLATION
2.1 Location
When selecting a position for your unit, you should make sure the floor is flat
and firm, and the room is well ventilated with an average room temperature
o
of between 16
C and 38
cooker, boiler or radiator. Also avoid direct sunlight as it may increase the
electrical consumption. Extreme cold environment temperatures may also
cause the unit not to perform properly. This unit is not designed for use in a
garage or outdoor installation. Do not drape the unit with any covering.
When installing the unit, allow 40 cm (15.7 inch) of free space at both sides,
15 cm (5.9 inch) at the rear and 20 cm (7.9 inch) at the top of the unit. This
will allow cold air to circulate around the refrigerator and improve the
efficiency of the cooling process. The door can be opened to the right or the
left, depending on what better suits the location. Please ensure there is
adequate space for the door to fully open.
2.2 Reversing the Door Swing
Tools Required: Phillips style screwdriver / Flat bladed screwdriver /
Hexagonal spanner
◆ If you want to have the door swing reversed, we recommend that
you contact a qualified technician. You should only try to reverse the
door yourself if you believe that you are qualified to do so.
◆ Ensure the unit is unplugged and empty.
◆ Adjust the two leveling feet to their highest position.
◆ To take the door of it is necessary to tilt the unit backwards. You
should rest the unit on something solid so that it will not slip during
the door reversing process.
◆ All parts removed must be saved to do the reinstallation of the
door.
◆ Do not lay the unit flat as this may damage the coolant system.
◆ We recommend that 2 people handle the unit during assembly.
o
C. Avoid locating your unit near a heat source, e.g.
3